Results 1 to 2 of 2

Thread: Estimate on making a slotted bracket? Or where to find one?

  1. 08-28-2014, 1:18 PM #1
    Mike vonBuelow's Avatar
    Mike vonBuelow
    Mike vonBuelow is offline [OP] Member
    Join Date
    Oct 2010
    Location
    NorCal
    Posts
    369

    Estimate on making a slotted bracket? Or where to find one?

    So I find myself making a home-made table for my new wood lathe, and I'm needing a slotted bracket as shown in the pic below (supporting the motor, on right)

    pulley.jpg

    Anyone have an idea on what it would cost to make one? Or suggestions where I might find something usable?

    Thanks in advance
    Mike

    Proud 24-yr USAF Veteran

    COMPUTER: Dell Optiplex 620 - XP
    LASER HARDWARE: Pinnacle 25W Mercury,     LaserPro 50W Explorer
    SOFTWARE: Corel X3, CS4 Suite, Photoshop Web Suite CS3, Solidworks
    FIRMWARE: My brain

    Reply With Quote Reply With Quote
  3. 08-28-2014, 2:31 PM #2
    Bruce Page's Avatar
    Bruce Page
    Bruce Page is offline Moderator
    Join Date
    Feb 2003
    Location
    In the foothills of the Sandia Mountains
    Posts
    16,639
    You could buy one like this: http://www.grainger.com/product/DAYT...tor-Base-6YTR0
    Or, you could buy some door hinges and make it yourself.

    Here's a sketch of one I made.
    Attached Images Attached Images
    Last edited by Bruce Page; 08-28-2014 at 2:54 PM. Reason: added sketch
    Please help support the Creek.


    "It's paradoxical that the idea of living a long life appeals to everyone, but the idea of getting old doesn't appeal to anyone."
    Andy Rooney
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules