3d masks

[stan kern]

http://youtu.be/pDI5mzU0UDg african masks

used *.stl files to make these masks

[Bill Munroe]

Very, very cool, Stan!

[Bruce Page]

Verrrry cool! Did you generate the stl file?

[stan kern]

No i googled *.stl 3d african masks and I found about 7 and picked these four ,then stuffed them into aspire and generated a toolpath to match up with 2 in thick butternut
I also had to use long end mills ,which can snap if you push it.
I also use a collett extension from MLCS in USA which extends my router collett

[Russ D Wood]

Stan, whose long endmills did you use? Russ

[stan kern]

they come from carbide.ca and i also use 4 in ones too