G.W. Weike LC6090 using LaserCut 5.3 engraving only in one direction

[Dave Shefley]

Had to reload my LaserCut 5.3 software, now only engraving in one direction, and I cannot find the switch to make it bi-directional again. Any thoughts would be appreciated!! Also using CorelDraw x5

[Casey kerner]

I believe it is on the cut settings window when you double click on it.

[Dave Shefley]

I believe it is on the cut settings window when you double click on it.

Thanks Casey, it ends up in the "Set Engrave Options" when you are setting Speed, Power and Scan Gap!!

Issue resolved!

Dave

[Casey kerner]

No problem, glad you figured it out!