Has anyone ever had a situation where their tube is firing but it's only coming through the laser head in spots?? I had a job going this evening and the laser was working fine. Then I noticed it's only marking on the outside edges and not in the middle. It would be real bright on the outside edge then fade out completely. The tube it lighting up the whole time though. It's after hours for the tech line but I am dead in the water for the weekend if this persists!! I have noticed I'm having to adjust settings I have previously used as it seems like the laser is losing power. I did a few small circles this evening after all my problems and the outside edge of the circle, like 1/16" is deeper than the rest of it. Like the power isn't consistent throughout. I'm trying to upload pics to show what I mean but my computer isn't cooperating.
CorelDraw Graphic suite X7
Engravelab V9
Boss LS-1630 60w laser