Let me say that without question my favorite tool I own is my Makita LS0714 mitre saw. It's small light accurate and I love it. I just found out though somehow my zero detent has some how gotten a little slop in it. It's the only slot on the saw that has any slop so unfortunately it's not the selector rod it has to be the actual slot itself. Anybody have any experience or any good ideas on how to take the slop out of the hole. The only thing I can come up with is to fill the slot in with JB cold weld and then file it out till the rod fits snugly. One problem I see with this is while the hole might be snug it has to be centered or the zero could end up being slightly off.