The table and bench tops are stunning. Nice job. How did you flatten the table top?
Contributor
The table and bench tops are stunning. Nice job. How did you flatten the table top?
Contributor
Gorgeous wood and finish! A well executed first big project in my opinion.
Ken
So much to learn, so little time.....
[OP]
Member
I would have been in trouble if too much flattening was required. I used the domino height adjustment setting to get a consistent domino hole on both sides of each board. I then used a hand plane to smooth the transitions. Most of the joints lined up perfectly. So in short, domino, hand plane and a lot of beginners luck.
Originally Posted by Joe A Faulkner
Posting Permissions
Reply With Quote