SOOOOO NICE !
I need one or two of those.
I was wrong about the rail . . . it IS up off the floor.
(you moved it didn't you ?)
Ha, ha,
My bad.
Sharpening is Facetating.Good enough is good enoughButBetter is Better.
Nicely done!
Perhaps I missed it but what's the approximate dimensions?
I got cash in my pocket. I got desire in my heart....
Thanks Fellas!
Winton, the bar is still on the floor, thats just a weird shadow.
Judson, it's about 43" long, 15" wide and 18.75" tall. The weird length is due to my not wanting to have a cut off, I simply cut the board and half and the length was set.
Bumbling forward into the unknown.
Yah sure . . . you are a closet metric measurement user like me and don't want to own up.The weird length is due to my not wanting to have a cut off
Rail on the floor
You have the nice carpet so that will absorb some chips.
I am wondering about the narrow gap (the main slot). I would no way be able to keep my line coplanar over that slot and I would wind up sawing into the bench half the time.
Let me know if it is just me or that you find that true.
I have sure enjoyed seeing this thread !
Thank You !
Sharpening is Facetating.Good enough is good enoughButBetter is Better.
Well I don't think that my saw benches slot is as narrow as Brian's I haven't sawed into it at all. And if/when I do, oh well... its part of being a saw bench.
I got cash in my pocket. I got desire in my heart....
I should have said that I am trying to judge the slot before making my saw benches.
Probably have to be two inches judging by my hand ripping results.
Sharpening is Facetating.Good enough is good enoughButBetter is Better.
The slot is 5/8". So far so good, part of the reason I made it narrow was to support rips in thinner stock.
Bumbling forward into the unknown.