Originally Posted by
Steve Huffman
If we haven't yet cleared up the power requirement for the GO766 it is a 15 amp 220v single phase. I got lucky as right behind the shop wall where my lathe is going
is my garage where I have a plug in for a plasma cutter with the exact same plug in. I simply will have to drill a hole on the wall and plug in the lathe. So if the cord is at least
5 foot, I'm all set.
I think the cord on my G0698 is about 5 ft.......never actually measured it, but I think it is close to that, maybe 6 ft. If length is a problem, that is easily solved........purchase some 10-3 wire from an electrical supplier and put the correct end on it, to make a 220v extension cord.......not sure about the G0766, but my G0698 has a NEMA-16 plug on the end of the cord.
Remember, in a moments time, everything can change!
Vision - not just seeing what is, but seeing what can be!