Help Laser not engraving

[Matt McCoy]

...Is the 100 minimum speed unique to LaserCut 5.3 or does it apply to all versions?

Does 100 represent 100% in LaserCut? If so, is power the only variable setting?

[Bert Kemp]

I don't understand what your asking, the 100 is the speed, and min speed that the laser will work is 100 and I believe it refers mmps . Speed and power both can be set. Dose that answer your?

Does 100 represent 100% in LaserCut? If so, is power the only variable setting?

[Tommy dunn]

I'll remember that one

[Dave Sheldrake]

speed is MM per second and power is percentage Matt

cheers

dave

[Ernie Balch]

I run lasercut from Corel X4 this method works great and is explained on the RabbitlaserUSA site. I have found it is best to establish a separate folder for each job so the parameters are remembered with that job. If you put all the laser files in one directory you will have to check and correct the parameters every time.