[OP]
Member
Drill/Driver Hanging Station
I filmed the build on my YouTube Channel. Please check it out! http://youtu.be/ALn9zyUp3_o
My old unit served me well, but I could incorporate some storage and increase the quality a little bit.
The build consists of MDF, 3" PVC Pipe, Glue, Pocket screws, paint.
Primary construction method was butt joints with glue, and pocket screws to hold the cabinet in place.
If you have any more comments, questions or suggestions please leave them here or on YouTube.
Last edited by Andy Glass; 03-13-2015 at 9:19 AM.
Member
Bright! I like the color. I see you're a Makita man. Are you able to differentiate between the drills and the impacts from the backside, or do you always put the drill to the left, impact to the right? I'm curious, because I also have a hanging setup and point my out.
Where are the chargers?
It came to pass...
"Curiosity is the ultimate power tool." - Roy Underhill
The road IS the destination.
Contributor
That is very slick. I like it!
Member
It would cost me a fortune to build that as I would have to buy 5 more drills!!!
Very nicely done. Cool organizing fixture.
"A hen is only an egg's way of making another egg".
– Samuel Butler
Moderator
Beautiful. I read a tip on using 3" pvc for drill storage a few years ago in Family Handyman. Your execution is prettier than mine.
Member
And this is a problem why?Originally Posted by Tom Giles
It would cost me a fortune to build that as I would have to buy 5 more drills!!!
It came to pass...
"Curiosity is the ultimate power tool." - Roy Underhill
The road IS the destination.
Posting Permissions
Reply With Quote