I have things pretty much figured out on the new to me, ULS V460-50. Origin now is the next thing on the list.
This is a 24x18 size machine and the factory Origin appears to be about 1 inch or 25 mm off the rulers in the upper left. However when I put in a test piece it appears to move over a distance and starts the project. So is there a way to have the Origin set and not have that "move over" distance?
I have customer supplied pre-cut to size material pieces that have be centered.
I tried resetting the Origin and again it moves from that pre-set spot, wherever it is set.
Is there a way to have the red dot trace the bounding box before I start the actual project?