220mm rebate cutter

[Ralph Butts]

Is there an 1-1/4" bore variant of the 220mm (or imperial equivalent) rebate cutter? I am considering a set of larger rebate heads for my shaper. I have seen the Felder offering, and I like them, but they are only available in 30mm bore.

[Rod Sheridan]

I have that tenon cutter.

Buy it and have it bored to 1 1/4"..................Regards, Rod.

[David Kumm]

Have you checked with Rangate? Oella might be another source. Leitz and Garniga, maybe Zuani should make them. I think the Felder are made by Stark. Dave

[Ralph Butts]

Thank you David for the sources. I had only checked Oella's website. Rod I did not know if boring was an option. I wonder if the additional cost will make another option more cost effective. The Felder heads are priced competitively.

[Joe Jensen]

Rangate is great, they carry 1 1/4" and 30mm. I would call and get a price from them first. When I tooled up for my big shaper they were a good bit cheaper than Felder for better tooling.

[Ralph Butts]

Thanks everyone. Rangate rocks!

[Rod Sheridan]

Thank you David for the sources. I had only checked Oella's website. Rod I did not know if boring was an option. I wonder if the additional cost will make another option more cost effective. The Felder heads are priced competitively.

OMAS also make that size of cutter............Rod.