I've got a two-car garage shop next to my two-car garage that is used for cars.
I've not locked down my tool placement, and I have everything on roller bases. That said, the oliver 270D and the D&W 20 don't really move that well even on bases. Just too heavy. :-)
I'm currently using a rollaround delta unit that is just not adequate, but I have centrally located. Getting rid of the floor space taken up by this is going to really help.
Not to mention it won't keep up with the jointer.
I'm planning to order a clearvue CVMAX, run an 8" pipe to the middle of the shop, and drop a flex 6" from the middle long enough to reach to my other tools, and once I get a stable tool location setup I'll worry about more static setups.
Think this will work ok? It's not final or ideal, but still so much better than my current state.
-Bob