Greetings all,
My laser was delivered yesterday. It will be a bit before I can install it as I have to wait on Civil Engineering to run the power...
In the meantime I'm putting in to have my workstations upgraded too. Right now I have 4, older HP 32 bit Win 7 computers.
I want to replace these and 4-24" monitors. It's been ages since I researched computers/monitors and looking for input.
I know I want to go 64 bit, lots of speed and memory...
It appears all my equipment will run on Win 8, which is good!
I understand if this needs to be deleted as it's only indirectly related to lasers and engraving.
Any and all help will be appreciated!
Thanks all!