Results 1 to 2 of 2

Thread: MagicTouch on Acrylic/Glass with ODR Paper

  1. #1

    MagicTouch on Acrylic/Glass with ODR Paper

    I have a project which could justify going with the Magic Touch system. I'm looking to do full color on 3/4" acrylic or glass using the ODR paper. I've seen it a few times at the trade shows but I never trust what I see at the trade show.

    Worth purchasing for that purpose or should I stick with outsourcing it with a direct to substrate printing?
    Equipment: IS400, IS6000, VLS 6.60, LS100, HP4550, Ricoh GX e3300n, Hotronix STX20
    Software: Adobe Suite & Gravostyle 5
    Business: Trophy, Awards and Engraving

  2. #2
    Ross

    I use ORD but not often. My results have been good but most of my projects have been smaller--4" x 6" or less and all have been on acrylic.

    I recently had to buy a new laser printer for doing monochrome sublimation and I bought a new dye sub system (after swearing never again) so my need for CLT has all but disappeared. So I guess I would advise outsourcing.

    Here is an example on 1/8" acrylic. No doubt will raise a few eyebrows about the logo.
    Attached Images Attached Images
    Mike Null

    St. Louis Laser, Inc.

    Trotec Speedy 300, 80 watt
    Gravograph IS400
    Woodworking shop CLTT and Laser Sublimation
    Dye Sublimation
    CorelDraw X5, X7

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •