have a large group of auger bits to stash...somewhere.
drill bits.jpg
threw some tools onto the bench, and made a few parts
tool pile.jpg
The boards standing up?
dovetailed corners.jpg
White Oak scraps. Made a few dovetails. Glued up a panel
glue up.jpg
Mostly 1/2" stuff. Got the rest of them dovetails made. Glue-up is sitting on the box's sides
dovetailed corners.jpg
Seemed the more I made, the better each set got. Made the tails first on the first corner...meh. Switched to pins first..much better
stand up.jpg
Laid out the bits, and a small inset piece
auger bit layout.jpg
Still have at least three others to place in there. Getting "Photo-Bombed" by a plane
rebate plane.jpg
Sold by wards, made by Stanley #78. Need it for some rebates in the bottom panel. Need to mill some grooves, too
Have a couple pieces of Curly-looking Maple to make a lid. They are now trimmed to length, edge jointed , and sitting in the clamps.
Taking a short breather right now ( COPD kicking in) but have one rebate cut. When breathing returns to normal, I might get the others milled.
This might take a few days to build....