Have some walnut to glue into a table top, and other parts. Used a Stanley No.7c T-8/9 as a Jointer
jointed edges.jpgClamped a pair into the leg vise
jointer plane.jpg
Then ran this along until the edges matched. Glued the two up
glue up.jpg
And let it sit awhile. Today, I unclamped the panel, and went about flattening to make it a table top
IMAG0308.jpg
Made a lot of shavings, too...
IMAG0307.jpg
But..there was a section right along the glue line, one side was a bit higher. No.7c just glossed over it.
Got out the No.5c, with a cambered edge. A couple swipes down the joint, high spots were gone. Cleaned it up with a No.4, T-12SW
IMAG0309.jpg
Time to latouy some other parts..
IMAG0311.jpg
And used a Craftsman to square the ends of the new aprons...
IMAG0312.jpg
So...between the planes, and the Mitrebox...I think I got my Cardio Workout today....whew.
Legs will get some curves, there will be a stretcher on the ends for a bottom shelf. Shelf will need to be a glue up, as well. More plane work
Undecided on the edge treatment......curves? Ogee? Roundover? Au Natural? we'll see...right now, I am sitting down and kicking back for the night....