[OP]
Member
Here is my problem I run into.
I want to rip a board but the distance between the right side of the blade and the fence is to narrow for the gripper to fit through.
Now I have to set up the middle leg and straddle the leg, that is all fine and good, but now the right side of the gripper isn't wide enough to sit all the way over and against the fence.
Do they make some sort of an adjustable width extension for the gripper?
Member
What is a gripper
Member
Last edited by Al Launier; 04-16-2016 at 10:18 AM.
Thoughts entering one's mind need not exit one's mouth!
As I age my memory fades .... and that's a load off my mind!
"We Live In The Land Of The Free, Only Because Of The Brave"
“The problems we face today are there because the people who work for a living are outnumbered by those who vote for a living."
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery." Winston Churchill
[OP]
Member
ahhh.. there ya go, that should work
Member
I used an old jointer pushblock. Had a bin full of them
Posting Permissions
Reply With Quote