Little box..
IMAG0009.jpg
Getting close....
IMAG0010.jpg
Might try to find a few labels?
Even duplicated the cutter stowage
IMAG0007.jpg
Not sure how all these parts were packed into the box
IMAG0008.jpg
I guess this will just have to do.....
Little box..
IMAG0009.jpg
Getting close....
IMAG0010.jpg
Might try to find a few labels?
Even duplicated the cutter stowage
IMAG0007.jpg
Not sure how all these parts were packed into the box
IMAG0008.jpg
I guess this will just have to do.....
Nice. How many finger joints did you have to cut?
David
Nice!
They Look like Bee boxes, which tend to use finger joints, although beekeepers tend to call them dovetails for some reason. Did you cut those by hand? I am making boxes to hold tools too, getting ready for a move.
Not sure where I found these, but they may helpcutters2_SW_all.pngp13-stanley-no-45-box-graphics-top-decal.jpg p14-stanley-no-45-box-graphics-side-stanley-decal.jpg p15-stanley-no-45-box-graphics-side-no-45-decal.jpgno45_sw_labels_green_8x10.pngHope these help.
Mike
From the workshop under the staircase, Clinton Township, MI
Semper Audere!
Four cornera= four sets of fingers My first through fourth ever setsof finger joints, all by hand.
Handsawn, then pop the waste out with a chisel. Dovetails were getting a bit boring to do, anyway. Existing box was finger jointed, I thought I might as well give them a try.
Thanks!! The 45 for tis box came from Roxton Pond, Que. Canada. I will see IF I can print these out...thanks.
Good one Mike.
David
Looking like I am getting closer to the finish line, now..
IMAG0007.jpg
Varnish is now on..
front view.jpgback view.jpgend view.jpglid open.jpg
For some reason, I didn't finish the insides.....maybe at a later date, eh?
Need to find out where the boss put the printer paper.....then maybe I'll try to print a few labels......IF I can find the Roxton Pond labels....
Thanks to Mike's little post about labels
IMAG0001.jpg
Printed out a few, cut them out, spray adhesive to attach...hoping I get then in the right spots
IMAG0003.jpg
will do for now...
Well, calling it done, for now. Will be on the lookout for the two match cutters, the depth stop for the slitter, and maybe a screwdriver. Plane is to be a user in the shop. OEM box is to be displayed on a shelf..empty.
Fun little box to build, though.
Glad they were useful to you. Box looks great.
Mike
From the workshop under the staircase, Clinton Township, MI
Semper Audere!
Fantastic little project!
Nice box Steven. That 45 has a nice new home. I think you will find it useful too. i use mine a good bit. A little finicky to set up at first, after a few set ups no problem getting it to work.
Jim