I bought this off of Craigslist today along with a bunch of other re-sharpened endmills. It's 2-1/4 diameter by 60° with a 1" shank.
I figure I could make some serious sliding Dovetails with it.
[OP]
Moderator
I bought this off of Craigslist today along with a bunch of other re-sharpened endmills. It's 2-1/4 diameter by 60° with a 1" shank.
I figure I could make some serious sliding Dovetails with it.
Please help support the Creek.
"It's paradoxical that the idea of living a long life appeals to everyone, but the idea of getting old doesn't appeal to anyone."
Andy Rooney
Contributor
Now all you need is a Bridgeport, with power table, and you will be in business. Hope you didn't pay too much
[OP]
Moderator
Nah, I'll rig it up to run in my router table. My PC 7518 should handle it no problem.
"It's paradoxical that the idea of living a long life appeals to everyone, but the idea of getting old doesn't appeal to anyone."
Andy Rooney
In Memoriam
If that 7518 accepts that 1" shank tell me how you did it.
Posting Permissions
Reply With Quote