I am trying to resaw some walnut veneer and I am getting some thickness variation.
The board is 6" wide and 12" long.
I have resawed next to the fence (inside) and outside the blade with the same result.
On the leading edge into the blade I get .016" and the trailing edge is .026"
From top to bottom I get a variation of .003"
The top to bottom variation is a squareness adjustment but .003" is not bad.
I can't tell if the variation I am getting between leading and trailing ends is due to the way I am feeding the board or an adjustment.
Is this an adjustment I could make to fix or human error?