Page 3 of 3 FirstFirst 123
Results 31 to 32 of 32

Thread: Looking for a jointer.

  1. 07-01-2016, 9:49 AM #31
    Randall J Cox
    Randall J Cox is offline Contributor
    Join Date
    Mar 2016
    Location
    Exeter, CA
    Posts
    693
    I used a 6" Craftsman (used) for 20 years before I upgraded to an 8" Powermatic. Wish I had done it much sooner! Randy
    Reply With Quote Reply With Quote
  2. 07-01-2016, 10:48 AM #32
    Rich Riddle's Avatar
    Rich Riddle
    Rich Riddle is offline Contributor
    Join Date
    Mar 2012
    Location
    Virginia and Kentucky
    Posts
    3,364
    I progressed from a 4" Craftsman to a 6" Delta, to a 8" Jet, and then just jumped up to the 14" because purchasing a jointer too small was costing me money every time the shop needed an upgrade. It's far cheaper to buy the size you really need in the future; trust me on that.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules