problems with z-axis control

[Bobby Orr]

I have a gecko G540 - everything was fine, then during a project run, it just flipped out. i stopped it, I have a planet CNC USB controller Mk3/4 hooked to it, no matter if I move it manually or via software the z-axis will go in the right direction at first but then starts going the wrong way and is very sporadic. I have unplugged everything many times.

I have taken the gecko g50x from the 4th axis and moved it to the Z-axis, - same
I have tried x & Y in the z axis port - they work properly
I have tired the z into the X & Y - tries to move not properly
I have a new motor - same end result
I have a new wire - same end result

any other ideas? I am not sure what else to try?

thanks

[stan kern]

check the terminal blocks ,the multi connector ..mine had to be replaced ,they seem to act up after a few years (drive connector)

[Bobby Orr]

thanks, that was my last thing to try