I am trying to find a double curve ogee router bit for a cabinet door edge. I have checked on most of the tool sites such as Amana and Freud, but they don't have anything close.
Any thoughts on where else to check?
I am trying to find a double curve ogee router bit for a cabinet door edge. I have checked on most of the tool sites such as Amana and Freud, but they don't have anything close.
Any thoughts on where else to check?
I can't determine what a double curve ogee is. Aren't all ogee's double curve?
There are numerous ogee bitts. Can you draw what you are looking for?
I found one on the following link.
http://www.infinitytools.co.uk/router-bits/ogee-bit/
Last edited by lowell holmes; 08-31-2016 at 4:46 PM.
Perhaps "cove and bead" is what you mean?
Check the MLCS website. While I wouldn't recommend you buy from there if looking for higher quality bits, but perhaps perusing their index of router bits will give you the correct name for the profile.
Something like this?
Check out the bits at MLSC http://www.mlcswoodworking.com/shops...forming_anchor . I have purchased bits from them and been completely satisfied. I especially like their Katana series.
Ken
So much to learn, so little time.....
That is pretty close Jay, and the closest one I could find. Here is a photo of the edge. What I have seen is that most are a taller vertical bite and what I need is a shorter vertical size and longer horizontal one. I thought about using a raised panel bit, but it just cuts too deep. I believe the total vertical cut is about 3/16".
IMG_20160822_201628245.jpg
Last edited by Mark Blatter; 08-31-2016 at 9:59 PM.
Check the "door edge" bits at the top of this page:
http://www.mlcswoodworking.com/shops...ip_bits_anchor