Tired of burning my small pieces and not wanting to make a dedicated bed I cut a bunch of pins that would fit just right into the honeycomb table.
Attachment 346373
The base is pointed so I can easily insert through a piece of paper with a "T" to keep it from falling through and then a 2mm x 10 mm peg on top.
I placed them at least 3 to a piece. The paper was a bit tough to remove. I guess I could use tissue paper next time....or just leave it.
I can place them all over my table to hold up large pieces or I just cut out pieces and just lay over the pegged area I'm going to cut.
Now I have much less burn.
My attachment shows for me but for others not valid so I just pasted into message