That is all. Sorry no pics, but after so many frustrating weeks, it was great to have a day where everything went right. Now if the waterlox finish comes out ok on walnut then I'll really be jacked.
[OP]
Member
That is all. Sorry no pics, but after so many frustrating weeks, it was great to have a day where everything went right. Now if the waterlox finish comes out ok on walnut then I'll really be jacked.
Moderator
Yea, time to celebrate! When I have a day like that I try to get back into the shop as soon as possible in case it's a streak.
Member
Last time after I had a day like that... The alarm clock went off.Originally Posted by Dave Macy
-Tom
Contributor
Don't know if I ever get a day like that, must feel good
If the Help and advice you received here was of any VALUE to you PLEASE! Become a Contributor
Rabbit RL_XX_6040-60 watt Laser engraving/cutting machine
Lasercut 5.3
CorelDraw X5
10" Miter Saw with slide
10" Table Saw
8" bench mount 5 speed Drill Press
Dremel, 3x21 Belt Sander
Member
You lucky so and so!
I was once a woodworker, I still am I'm just saying that I once was.
Chop your own wood, it will warm you twice. -Henry Ford
Contributor
Congratulations. I like Waterlox quite a bit but tend to select Penofin for walnut.
Contributor
Congrats! Without a day like that every once in a while it can be hard to motivate and be excited for time in the shop.
I used Waterlox on just about everything until I discovered Arm-R-Seal. Worth a try IMO. Oh, and I highly discourage the use of the Low VOC Waterlox. Original is much better.
[OP]
Member
Never heard of Penofin. Have any pics with your walnut?
Posting Permissions
Reply With Quote