That is all. Sorry no pics, but after so many frustrating weeks, it was great to have a day where everything went right. Now if the waterlox finish comes out ok on walnut then I'll really be jacked.
That is all. Sorry no pics, but after so many frustrating weeks, it was great to have a day where everything went right. Now if the waterlox finish comes out ok on walnut then I'll really be jacked.
Yea, time to celebrate! When I have a day like that I try to get back into the shop as soon as possible in case it's a streak.
Don't know if I ever get a day like that, must feel good
If the Help and advice you received here was of any VALUE to you PLEASE! Become a Contributor
Rabbit RL_XX_6040-60 watt Laser engraving/cutting machine Oh wait its a 3D Printer my bad LOL
Lasercut 5.3
CorelDraw X5
10" Miter Saw with slide
10" Table Saw
8" bench mount 5 speed Drill Press
Dremel, 3x21 Belt Sander
You lucky so and so!
I was once a woodworker, I still am I'm just saying that I once was.
Chop your own wood, it will warm you twice. -Henry Ford
Congratulations. I like Waterlox quite a bit but tend to select Penofin for walnut.
Congrats! Without a day like that every once in a while it can be hard to motivate and be excited for time in the shop.
I used Waterlox on just about everything until I discovered Arm-R-Seal. Worth a try IMO. Oh, and I highly discourage the use of the Low VOC Waterlox. Original is much better.