I loaded a file into lasercut and it loaded just fine but when I calculated the file it said over lap issues OK I had text that over lapped. Welded the text and then loaded in to laser cut except now it won't load just keeps spinning the hour glass. I tried a couple time and same thing. OK I go back undo the weld and remove the offending text lines with the virtual delete tool. Iagain load into lasercut and it loads no problem . But when I calculate it again says over lap and also says open polyline YIKES!!!! So I throw in a test piece of scarp and run it to see whats going on. Well it starts engraving but when it gets to the word WHISKEY the laser moves back and forth like its engraving but its not engraving and then when its done not engraving WHISKEY it then engraves the rest no problem. I can see any overlap or open lines in WHISKEY so whats going on?????see file Kevin Pope.cdr going
CRAZY