Page 2 of 2 FirstFirst 12
Results 16 to 17 of 17

Thread: Restoration and motorization of a 110yr old cane mill

  1. 12-06-2023, 7:55 PM #16
    Richard Hash's Avatar
    Richard Hash
    Richard Hash is offline [OP] Contributor
    Join Date
    May 2003
    Location
    Pagosa Springs, CO
    Posts
    59
    Jerry, I had a metal worker mill a key slot into the main roller shaft that matched the key slot in the bushing that fit into the main chain sprocket. Pretty typical setup for anything sliding onto a shaft. If you PM me your email address, I can send you a link to an entire Google Photo album of the entire restoration, there are a few pictures you might be interested in.
    Last edited by Richard Hash; 12-06-2023 at 8:08 PM.
    Reply With Quote Reply With Quote
  2. 12-07-2023, 11:13 AM #17
    Jerry Johns
    Jerry Johns is offline Member
    Join Date
    Dec 2023
    Posts
    2
    Wonderful! Thanks. Jerrylanejohns@gmail.com
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules