I am about to install the Delta Uniguard 34-976 on out Delta Unisaw that has a Biesemeyer fence and a 52 inch extension table. The Biesemeyer fence system has a sturdy angle iron on the outfeed side of the table that interferes with the installation of the brackets for the guard. Rather than remove it and install a flat strap as suggested by Delta can I build it out with spacers to make it flush so I can hang the brackets for the tubes? I like the idea of having that rigid angle iron holding everthing together rather than replacing it with a flimsy strap. The angle iron is about 2 inches deep.
What solutions has anyone else come up with for this install who faced the same issue?
Thank you,
joe