I heard a strange noise and then the blade stopped. Got to checking and found a surprise. The belt was laying at bottom of housing intact, and the pulley flange had broken. It was likely the original pulley on the old Rockwell 14" (about 1950 vintage). It turned out that the pulley, 5/8" bore and 2 3/4"D is not a standard available locally, but McMaster Carr came through and will ship today. The 2 1/2 or 3"D available would have meant about 10% +/- blade speed change and I was not ready to make the change. Bandsaw Pulley.JPG