[OP]
Contributor
My Grizzly 15" Planner G0453P doesn't have the little springs under the knives, they just drop in so I can't use my knife setting jig. Is this how
it should be?g0453p-22d363e34dd52121f3d8cf22745123b1.jpg
Also, I just had the knives sharpened, so do I need to re adjust the rollers to the new knife height? They were nicked by staples.
Not sure what type of jig you have. Page 36 of the manual shows jack screws for height adjustment. I would set the knives to the height they used to be. If you did not write this down before removing them, the manual has the baseline settings.
Last edited by glenn bradley; 02-19-2017 at 12:28 PM.
"A hen is only an egg's way of making another egg".
– Samuel Butler
[OP]
Contributor
Thanks for that Glenn, I actually looked in the manual and see those jack screws now!
Posting Permissions
Reply With Quote