Does anyone know how thick Doug Thompsons scrapers are? The same question for Crown Pro PM scrapers?
TIA
Does anyone know how thick Doug Thompsons scrapers are? The same question for Crown Pro PM scrapers?
TIA
Give him a call.
My favorite DT scraper is the 1 inch wide by 5/16 thick. He does go wider and heavier. He used to carry a 3/8 by 1 1/4, and next one up was 1 1/2 inch wide and half inch thick. Personally, you don't need more than 1 inch wide, though 1/4 inch is a bit thin for heavy roughing. Look at D Way also. Some thing I never considered but learned after chatting with Eric Lofstrom was that you get a different burnished burr with V10 than you do with M42HSS. More experimenting ahead.... I think the steel turns a burr a bit better than the V10 does. I have been playing with the burnished burrs more, especially for shear scraping with scrapers...
robo hippy
I have a Serious Tool scraper. It is 1" wide and 3/8" thick. It took me awhile to learn how to use it, but I really like it and depend on it. They also have 1 1/2" wide and 3/8" thick. Both are made from A2 steel