Hi all,
I'm fairly new to all hand tools and learning as i go along. I need to make a very specific bracket to fix part of a machine. This bracket needs slots in it, like these;
DlmKJwi.jpg
How can I make these?
I had thought a series of holes then some filing with a dremel to smooth out the slot.
I have tried with a hand held power drill but lining them up was impossible. Each hole would be somewhat out of line with the previous despite all best efforts. Then i tried with a drill press, but the bit wandered into previous holes and wouldn't complete the new hole.
I had thought a series of holes then some filing with a dremel to smooth out the slot.
All advice would be appreciated!