Results 1 to 6 of 6

Thread: Delta 12-14 tablesaw base dimensions

  1. #1
    Join Date
    Sep 2016
    Location
    Modesto, CA, USA
    Posts
    9,889

    Delta 12-14 tablesaw base dimensions

    Any one know the base dimensions of the Delta/Rockwell 12-14 tablesaw. I would like to replace my Unisaw with one of those sometime. I need to weld up a new mobile base for the Unisaw and I figure if it is a few inches bigger I can use it latter under a 12-14 saw.
    Bill D.

  2. #2
    Join Date
    Oct 2007
    Location
    Cache Valley, Utah
    Posts
    1,722
    I'd go out and measure mine, but it's 850 miles away. If you don't get an answer here, go over to OWWM and someone there can measure theirs.

  3. #3
    I can measure in the morning I have a unisaw and we have a older 12-14 at work. it wont be a few inched larger. I'm thinking the cabinet base is more like 50% bigger both ways. 32-36", but i couldn't be sure till i measure.
    L.T.

  4. #4
    Join Date
    Dec 2005
    Location
    West Lafayette, IN
    Posts
    6,529
    Just go with "a lot bigger than your Unisaw".

  5. #5
    So 33" wide and 27" depth. I don't have the unisaw measurement but it's just under 24 x 24 i think.

  6. #6
    Join Date
    Sep 2016
    Location
    Modesto, CA, USA
    Posts
    9,889
    Well that plan is out. My unisaw is roughly 21" square at the base. So quite a bit smaller.
    Bill D.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •