Results 1 to 4 of 4

Thread: Rotary adapter for vacuum chuck

  1. #1

    Rotary adapter for vacuum chuck

    Have double sealed bearing and can't secure the vacuum. The leak is from the bearing.

  2. #2
    Join Date
    Apr 2013
    Location
    Valparaiso In
    Posts
    156
    Could you give us more info? Is your system commercially made or DIY? Bearing number? Type of lathe? Pictures would help.

  3. #3
    The bearing isn't made to hold vacuum. You need a rotating coupling with a hollow shaft going to chuck.

  4. #4
    Join Date
    Sep 2015
    Location
    San Diego, Ca
    Posts
    1,647
    Some thoughts:

    Many/most vacuum chucks use bearings.

    Some people confuse sealed (RS = rubber sealed) with shielded bearings. You would want the RS not shielded.

    I've seen some designs with a set of three RS bearings. A single bearing even if "double sealed" may not be good enough.

    You will also want to make sure that there is a (caulked) seal between the outer perimeter of the bearing and the holder and between the inner ring of the bearing and the shaft.

    Don't expect to get 29.5 " of Hg. It won't happen. You should be able to work fine if you can get into the 23 or 24" point. Some woods are so porous that you may not be able to even get to 15".

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •