Hi guys,
I am trying to put back both the RF unit and the tube that have been recently repaired by Synrad and I cannot figure out where exactly two brackets should be screwed in on the RF unit.
It is pity I did not think about it before and did not take a picture. I was more worried about cable connections and I did not think these two brackets would be any problem to put it back. I remember that the RF unit was installed with its fans looking down towards the floor and with all connections located on its left side(if you stay in front of the machine). Based on the holes positions for the brackets at the bottom of the machine they go on sides of the unit but I cannot see any holes for screws on the unit sides. There are 6 screws on each side of the unit and four of them match the holes on the bracket but these screws are all in place which would not happen if I removed them to get the brackets off. There is a chance though that Syndrad put some screws back but it is very unlikely
If anybody has the same model can you please take a picture of the bottom cabinet of your machine where your RF unit is installed.