Kees; jarrah is a hard and dense timber that has a moderate blunting effect on hand tools. Its likely 2 fold in difficulty to hand mortise out compared to quality European Beech.
Australian Jarrah;1860 lbf
European Beech; 1450 lbf
American Beech; 1300 lbf
Last edited by Stewie Simpson; 05-08-2017 at 4:20 AM.
Oooo, look. . .Stewie and Derek with their Jarrah planes.
That is one huge, good lookin' monstrosity. Amazing that stuff is hard enough you need to sharpen your floats.
The Barefoot Woodworker.
Fueled by leather, chrome, and thunder.
Adam,that is an old heavy duty vise for a metal milling machine. Machinists would just say milling machine. But,I am not sure if everyone would know that the machine I refer to is for metal milling.
I did think the wedge would go further down. What's next? The opening for the shaving? You have kept a good thickness of wood on the sides. Will follow your first shavings with interest!
William; the tine ends of the wooden wedge extend all the way down to the commencement of the cap irons front curvature. Mortising out to receive the rear tote is next on tomorrow's to do list.
The front of the mouth opening and wear angle have both been squared up. The sole of plane has been dressed back to flat with the double iron in tension. (Little change noted in flatness). The sides and top have been cleaned up to remove all the lay-out markings. The mortise housing for the rear tote has been completed and the hide glued in position. The glue will be left to harden overnight. Both ends of the planes stock still need to be cleaned up with a block plane, then its onto forming the profile bevels.
Last edited by Stewie Simpson; 05-14-2017 at 12:52 AM.
Looking great!
Not going to add the bevels around the top edges, and front and rear? They can add a great deal of charm to a plane if done right. I prefer the bold ones used in the 18th. C. myself. The worst ones were the final, barely rounded edges used in the 19th. C..
The same jack plane I showed before has 18th C. BOLD bevels. These bevels terminate in nice,clean, gouge cuts. If you are experienced,they can be done in one cut! Snick,snick,nick. The plane is sitting on a pair of Appalachian red spruce guitar top blanks. This is what the old time,sought after Martin and Gibson guitars used. Now nearly unavailable unless you own land where there are some spruce trees. Deer eat the young buds, causing no more trees to grow.
The existing trees are protected.
Last edited by george wilson; 05-14-2017 at 9:29 AM.
Both ends of the planes stock still need to be cleaned up with a block plane, then its onto forming the profile bevels.
George; after the end grains on the stock have been cleaned up, its onto forming the profile bevels. This plane design is based on the French style of plane making. Narrower escarpment side walls, and less width in the size of the bevels that run across the top and ends the stock (rounded profile), and no eyes carved into the cheek side walls.
Last edited by Stewie Simpson; 05-15-2017 at 2:18 AM.
Looks GREAT!
Appreciate the feedback Steve.