So... dug out the old Veritas grinder tool rest to regrind a chisel that got bunged up.
It's been a looooong while since I used it; I *thought* it was fairly goof-proof... but maybe not.
I indexed the chisel against the left side brass screw, and the brass pin of the Veritas grinding jig. I set the jig in the Veritas tool rest, and started the grinder at its lowest speed, using a 6" Norton white wheel. I'd also used a small square to check the chisel square to the face of the grinding jig.
Imagine my surprise when the edge came out almost rounded to one side. I thought maybe I had inadvertently put pressure on it somehow, and tried a few more times. About all I managed was to achieve a fairly ugly camber on a 1" chisel
I'm kinda of at a loss here. Any suggestions?