In another string I was talking about Popular Woodworking's Modern Chair. I am making one using mesquite.
There are slots in the wood, 1/4"X 1 1/2" and also 1/4"X 1". These are finished slots. I plan on drilling 1/4" holes
and chopping the slots with a chisel. Maybe I drill 1/4" end holes and drill a series of 3/16" holes between the ends,
then enlarge the slots with a chisel.
Do any of you have suggestions on how to make these slots. I have a drill press, router, and a router table.
I think a hand cut slot is best, but I'm not sure on how to approach making it. I also have the Lee Valley flat
cut saw, but it is too wide.
Thanks!