[OP]
Contributor
I have just updated to Coreldraw X8 due to a major systems crash basically starting over, many moons ago now; there was a thread here on the Creek how to set up your Corel preferences by a member. unfortunately that information is gone now to.
Does anybody know where I might get that information, and would be willing to share.
Keith Bragg
45 Watt Epilog Helix,Corel x3,PhotoshopCS2,Photgrave
Member
Keith,
That would be Roy Brewers video on youtube. Here is a X5 clip..........
https://www.youtube.com/watch?v=3rFpOWrG2ts
Trotec Speedy 300 - 60w, with Quatro CSA-626 fume extraction
Xenetech 1625 x2,
New Hermes TX pantograph, CG4 cutter grinder
Brady Globalmark2 label printer,
Assortment of custom tooling , shears & punches, heat bender.
Software: Xenetech XOT, Corel X3, Bartender label software
[OP]
Contributor
That is the one Tony Thank You.....I assume that these functions are about the same in X8, I will fined out soon.
Keith Bragg
45 Watt Epilog Helix,Corel x3,PhotoshopCS2,Photgrave
Posting Permissions
Reply With Quote