I will attempt to post a picture here of one of several plates that I just got done with. They are all maple, then I used my wood burner to burn the outlines of maple leaves and then used Prismacolor markers to all a little color to them. It all worked good until I started putting finish on. I was using Minwax antique oil. The orange and red colors worked just fine but the finish lifted a lot of the yellow color out. As a note, I had let the marker color sit for 2 days until I put on the antique oil. I know the markers are alcohol based so I wasn't expecting a problem with the color. What is your experience with various finishes over Prismacolor markers? Would wipe on poly work better? Or some other finish product? Thanks in advance Jaredthumbnail_IMG_0161.jpg