Thinking about getting a PC 557 Type #3 joiner to cut through spline slots on 45 mitred ends of 1x6 board laid flat, not standing on edge, using benchtop as registration, then use BB plywood cut into splines.
I don't have the joiner available in my hands yet, or I would figure this out myself.
I have tried to Google dimensions, width of cut, AND available BB, had some luck, but still not sure it will work in practice..
Interested in in practice experience.
So, is BB ply made in such thickness that would work well, w like Titebond 2 ?
Not too tight, not too loose ?
Thank you Gentlemen, Marc