i've got the grizzly 0715P table saw. it has enough power for all i need (so far).
i ran into a situation this morning ripping some pine 2x10x48"s. i was cutting it in 3" strips for a table top.
i started cutting it and approx. 4" in, it jammed the blade. i flipped it over long ways and tried from the other
end and it jammed again. i flipped it cross grain and tried again. it jammed up the blade again.
i had already cut two other 4 footers and one of them was the other half of this board (original 10' board.)
i checked moisture content and it was 15%. the other pieces were 12%-15%.
any ideas what would cause it to jam? and why only that half?
thanks all
rich