Dear PowerCreekers,
I want to resaw some boards to guitar veneers (about 6" wide or smaller).
I have an 80's Rockwell 14" Bandsaw that is a workhorse.
I also have a Kreg fence/resaw attachment that I've been trying to use.
It's honestly been very frustrating since it deflects about 1-1.7 mm during use.
My guess is that this is because it's bolted to one side of the table only.
I'm thinking of getting a Carter F A S T guide and making a fence with baltic birch plywood and some on/off magnets.
Can you guys give me insight?
I've had more success ripping freehand than with my Kreg fence, except for very small pieces of wood like binding.