This may sound like a dumb question, but, I'm in a spot with a customer, & dealing with their "specifics" shall we say. She walked into my shop a few weeks back, & being an older lady, I stopped what I was doing & asked her to have a seat. She had three pieces of paper in her hand. One with one of the projects drawn out to the letter. The other two had pictures of the projects she wanted constructed. And this young lady is a retired school marm at that! I look over her dream list, & ask the usual questions. How soon? Any particular colors? RUSTIC she says! As rustic as possible! Well, I can accommodate that part easy enough, I explained to her. Then we got around to the budget word. She says "I have no budget." I looked at her for a minute, & asked her if she had any idea what the price of barnwood was a bdft? She said no. I calmly said, well, you're probably not going to like it. On top of $25/hr shop rate. Her grin faded. So, after she left, & before I went back to the scroll saw, I was studying one of her pictures. It has v board in the project. Now, here's my question. How, or is there a way I can make this "V" board for her project at a reasonable cost? I've never worked with it, but no doubt, it's going to be hard to find. Any help would be greatly appreciated. And my sincere apologies for the length. Brad.