Results 1 to 3 of 3

Thread: Where to find solid brass hardware?

  1. #1

    Where to find solid brass hardware?

    Been looking around trying to find solid brass hardware for my hard-sided gun case. Not having much luck.

    I will need the following items:

    1- brass 48" piano hinge
    2- brass locking latches (either w/key, combination or that use a small padlock)
    8- brass corners
    1- leather handle w/ brass mounting hardware

    Here's the problem. Most places have 1 or 2 of these items in solid brass (for example Rockler has solid brass piano hinges and corners but does not have a solid brass locking latch. Another place might have the corners but not the hinge or the leather handle w/ brass hardware, etc.)

    Does anyone know of a good source for these types of items? Thanks.
    If fishing is a sport I MUST be an athlete!"

  2. #2
    Join Date
    Aug 2005
    Location
    Glenmoore, PA
    Posts
    2,194
    Royce, I always look to Lee Valley for these sorts of things. I can't say that they have it because I didn't look for the specific items you mention but they are a good starting point.

  3. #3
    Join Date
    Mar 2005
    Location
    Anaheim, California
    Posts
    6,907
    I'm not sure you're going to find a solid brass locking latch: brass just isn't strong enough for a mechanism like that. Rockler has some combination latches made for briefcases that look pretty good, but they're plated. (page 110-120 of the current catalog...online probably just search for "briefcase")

Similar Threads

  1. Bedding Hardware
    By Bob Smalser in forum Boat Building
    Replies: 5
    Last Post: 09-17-2009, 4:35 PM
  2. Should I use solid brass or brass plated hinge?
    By Royce Meritt in forum General Woodworking and Power Tools
    Replies: 8
    Last Post: 11-01-2005, 11:25 AM
  3. Bed Rail Hardware...advice needed
    By John Scane in forum General Woodworking and Power Tools
    Replies: 16
    Last Post: 04-27-2005, 11:15 AM
  4. Where to find Tilt/Swivel Hardware for Office Chair
    By Bill Wiggins in forum General Woodworking and Power Tools
    Replies: 5
    Last Post: 03-24-2005, 11:28 AM
  5. @@#*&@ Brass Screws!!!
    By Dennis McDonaugh in forum General Woodworking and Power Tools
    Replies: 8
    Last Post: 10-13-2003, 10:04 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •