Hi all,
I'm interested in installing another in-line pressure regulator valve closer to the actual shop (currently about 40' of hose between compressor and hose coil in shop). Tired of walking over there to adjust the pressure.
My plan is to adjust the regulator near the compressor upward, and have the new regulator in the shop adjusted as needed for job @ hand.
This post has 2 questions:
1) Is having 2 regulators OK? Part of it is-I just don't want the hassle of taking first one out of the circuit
2) Is the current regulator in the picture good enough for taking moisture out for using a pin nailer, etc. No finishing equipment.
The compressor itself has an automatic intermittent bleeder @ the bottom.
I searched over Google, and was just confused. Don't need industrial set-up.
023.JPG
There is a small diaphragm visible in the picture, but no moisture
Thanks!