Results 1 to 4 of 4

Thread: Delta drill press spindle parts

  1. #1
    Join Date
    Oct 2008
    Location
    Chico, CA
    Posts
    61

    Delta drill press spindle parts

    I've lost the contact info for a company that deals in older/vintage shop replacement parts. My Delta drill press has a plate on the side that reads 43-7525. The upper spindle bearing seems to have gone south. It has a sleeve/collar pressed into it which seems to be a part of the bearing.

    Appreciate any leads or contact info for this company.

    Thks,
    Gary
    Granbury, TX

  2. #2
    Join Date
    May 2005
    Location
    So Cal
    Posts
    866
    Hammerscale dot com may be the place that can help. Good luck.

  3. #3
    Join Date
    Sep 2016
    Location
    Modesto, CA, USA
    Posts
    9,876
    If this is an extended inner race bearing good luck. On my walker turner 15" dp the upper bearing was like that . the engraved bearing number only refered to the outer race. I had to use a similar bearing with a bigger inner bore. and make a sleeve to fit. I think the outer race diameter was increased as well so the casting had to be bored to fit as well.
    A easier method would have been to make an oil lite bearing.
    Bil lD.

  4. #4
    Join Date
    Mar 2009
    Location
    Sterling, Virginia
    Posts
    644
    I recently finished my Walker Turner and Lynne at Accurate Bearings actually sourced them for me but they were expensive. $40.00 each. She deals with everyone over on the OWWM and Vintage machinery sites.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •