Decided to rehab this little fellow..
IMG_2211 (640x480).jpg
Little Giant? Worked on the sole...
IMG_2210 (640x480).jpg
Was a bit hard to check for flat....
IMG_2212 (640x480).jpg
May start a sharpening thread on that iron?
IMG_2213 (640x480).jpg
Cleaned up the cap iron...or is it a chipbreaker? Not a whole lot of parts to rehab..wasn't any rust, either
Put this all back together, trying NOT to cut any fingers on the iron's bevels...
IMG_2214 (640x480).jpg
Tried a few passes along the edge of a scrap board....this plane will also cut as a scraper..
IMG_2215 (640x480).jpg
Not much to hold onto...
IMG_2216 (640x480).jpg
Not sure if I can cobble up a handle. Rumour has it that there were two kinds of these planes...